But everytime an update rolls around one or more of the parametric constraints changes its function which makes the drawing incapable of being adjusted without an almost entire redraw and a rewrite of all the formulas related to the drawing. The whole point of using parametric drawings is that you can change parts of them later saving work. Having to spend two or five days a month fixing drawings for new features I don't want is so aggravating and expensive. I don't need new features, all I want is to come into work and be able to work on the same drawings the same way each day. So far we have about 12 hours into fixing one of our drawings and it is still not working.

The issue is related to constraints this time, everything shows as 'over constrained'. It is rare for updates to not cause problems. I think this is the third or fourth time this has happened and basically I'm getting to the point that I could keep using Fusion but only if I can stop the updates from happening.

About 160 hours of work, all of the drawings are vastly too complicated to 'just redraw' each time an update rolls around. So another update went through about a week ago and broke every single drawing again.

Stopupdates